Adsorption of hydrogen chloride on a copper powder sample at 25°C and at various pressures resulted in the following dataset 0,31 0,53 1,02 1,65 2,05 2,20 Pressure n/(mol kg) 1,00 1,54 2,49 3,22 3,35 3,36 Determine, using the Langmuir isotherm, the value of the equilibrium constant, the number of moles and the maximum coverage (theta) referring to the formation of a monolayer.

Adsorption of hydrogen chloride on a copper powder sample at 25°C and at various pressures resulted in the following dataset 0,31 0,53 1,02 1,65 2,05 2,20 Pressure n/(mol kg) 1,00 1,54 2,49 3,22 3,35 3,36 Determine, using the Langmuir isotherm, the value of the equilibrium constant, the number of moles and the maximum coverage (theta) referring to the formation of a monolayer.

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter15: Molecular Luminescence Spectrometry

Section: Chapter Questions

Problem 15.12QAP: Equations for the chemiluminescence determination of SO2 are given on page 383. Derive an expression...

See similar textbooks

Similar questions

Confirm that the following CO adsorption data on activated carbon at 273 Kfollow the Langmuir or Freundlich isotherm and determine the volumecorresponding to the complete coverage of the surface.
The data below are for the adsorption of CO on charcoal at 273K. Calculate the volume, in cm³, corresponding to complete surface coverage assuming that the adsorption of CO on charcoal follows the Langmuir equation. P/mm Hg 100 200 300 400 500 600 700 V/cm³ 10.2 18.6 25.5 31.4 36.9 41.6 46.1 Mass of sample of charcoal: 3.022 g; in each case, V has been corrected to 1 atm.
(Q3) (a) Derive the Langmuir adsorption isotherm in terms of pressure of a diatomic molecule for the case in which the diatomic molecule, A2, dissociates upon adsorption to the surface.
(Q3)(b) How is Langmuir adsorption isotherm different from Gibb's adsorption isotherm? (O2) Ca) Wh
The following data are for the chemisorption of hydrogen on copper powder at 25°C. Confirm that they fit the Langmuir isotherm at low coverages. Then find the value of K for the adsorption equilibrium and the adsorption volume corresponding to complete coverage. \ table V 3 [la, 25, 129,253, 540],[m², 0.042, 0.163,0.221,0.32|]] с
In the fluorination reaction of butadiene, the butadiene is adsorbed onto a catalyst C.To test the efficiency of the adsorption, the adsorption isotherm was determined.The volume of butadiene per gram of C varied as follows at constant temperature:p( kPa)- 13.3; 26.7 ; 40.0 ; 53.3 ; 66.7 ; 80.0V(cm3)-17.9 ; 33.0 ; 47.0 ; 60.8 ;75.3 ; 91.3At the temperature used, p* for butadiene is 200 kPa. Find a suitable isotherm for the data and determine Vmon. please assist.
Define the following terms :(i) Electrophoresis(ii) Adsorption(iii) Shape selective catalysis
+ Moore 5e_Ch11 SP2020.pptx: SP X * OWLV2 | Online teaching and lea X oping Cart | The UAB Blazer x VtakeAssignment/takeCovalentActivity.do?locator=assignment-take [Review Topica) [References) Use the References to access important values if needed for this question. In a study of the decomposition of hydrogen iodide on a gold surface at 150 °C HI(g)% H2(g) + % I(g) the following data were obtained: HI), M 0.401 0.201 0.101 5.05x102 seconds 519 779 910 Hint: It is not necessary to graph these data. (1) The observed half life for this reaction when the starting concentration is 0.401 M is s and when the starting concentration is 0.201 M is req (2) 2req The average rate of disappearance of HI from t=0 s to t= 519 s is Ms! (3) The average rate of disappearance of HI from t = 519 s to t= 779 s is Ms! (4) Based on these data, the rate constant for this v order reaction is Submit Answer Retry Entire Group 9 more group attempts remaining Cengage Learning | Cengage Technical Support Tch 55 F7…
а. Identify THREE (3) isotherm shapes that are typically encountered in an adsorption process for a single adsorbate and illustrate the behavior through equilibrium relations.
Explain how the phenomenon of adsorption finds application in each of the following processes :(i) Production of vacuum(ii) Heterogeneous catalysis(iii) Froth Floatation process
A student conducted an experiment to determine the concentration of benzene in an ethanol solution. Use the UV spectrum of the solution in a 2.0 cm cell. Within the spectrum, there was a peak attributed to benzene at 260 nm, with an absorption of 0.69. In a reference source, the student found that the adsorption of the benzene strip with ethanol was 2.95 x 10-3 ppm cm-. What is the molar concentration of benzene in the sample (mm of benzene = 78.11 g/mol)
b) Write the BET reduces to the Langmuir isotherm. =) The decomposition of ammonia on solid surface is inhibited by the adsorption of hydrogen to the substrate. Assuming that the adsorption of a gas simply limits the number of surface sites available for adsorption, derive expressions for the fractional coverage of H₂ and NH3. 2NH₂= N₂ + 3H₂