(+ T E 25 R1 15 D1 R2 20 D2 -V1 -V2 -V3

Q: : Let S = 120 cm², d = 4 mm, er = 12, and V. = 40 v, calculate acitance C and the total stored…

A:

Q: A RL network supplied with 10V battery (a)Find the mathematical expressions for the transient…

A:

Q: what is the kVA rating of the synchronous motor

A: Three Phase Synchronous machine- This Synchronous machine comprises of rotor and stator as it basic…

Q: If (IB= 25μA, Ic = 2 mA,VCE = 6v) design a Base Bias circuit and ensure that the Q-point in the…

A: Given the circuit, as shown below: If IB=25 μA , IC=2 mA , VCE=6 V, we need to design a base…

Q: of charge. The cell has a constant internal resistance of 0.01 Q and reversible

A: Current: I=dqdt Heat: H = I2Rt

Q: on to test the stability of the system with the following characteristic equation: ch. eq.=…

A: We need to check whether the given system is stable or unstable .

Q: inductive coil with resistance R and inductance L is connected in parallel with a 40-ohm resistance.…

A: In this question we have given parallel  circuit....We have to find out inductance of coil ....

Q: Q1.A. A sequence detector has an input w and an output z. The machine is a sequence detector that…

A: FSM is the output depends on a present state . Moore machine is the finite state of machine which is…

Q: ⇓ Given x[n] = {4, 6, 8, 3} Analyse a. s[n] = x[n - 1.5] b. z[n]y[n/2] where y[n] = x[-n + 2]…

A:

Q: A circuit consisting of a filter and an op-amp is shown in the figure below (fig. 7). If R1 = 5…

A:

Q: 0.1 vo 40 92 ww + is 20 Ω 50 µF 100 mH If is= 10cost(30t+20°) A, what is the value of vo(t)? USE…

A:

Q: Using Norton's Theorem, solve for current I1 in the given circuit below

A: The circuit given in the question is as shown below,

Q: A 1,200 kVA, 13kV, 3-phase Y-connected synchronous motor has a resistance of 3.59 ohms and a…

A: In this question we need to find a induced emf of motor at when fully loaded at 0.86 power factor…

Q: 5. a. Find the bandwidth of a series resonant circuit having a resonant frequency of 6000 Hz and a…

A: The impedance of capacitor and inductor will be same at resonance condition. Based on the resonance,…

Q: Q.1(a) Find the Fourier Transform of f(t) (1) f(t)=sin(at)+e-³¹u(t) f(t)=sgn(t) * tri 10

A: Given  Two functions, we need to find the Fourier transform of the signals. Please find the below…

Q: 6- The weekend was boring, (I didn't/ don't) do anything useful.

A:

Q: nano materials have high surface area property because small size little atom in the surface have…

A:

Q: Find the Laplace Transform of the functions

A: This question belongs to signal and system . It is based on the concept of Laplace transform of the…

Q: A step-up transformer is designed so that the output of its secondary winding is 2,200 V (rms) when…

A: Given: A step up transformer is designed to have V1=210 VV2=2200 V

Q: Example: A 7.46kW, 250V shunt motor takes a line current of 5A when running light. Calculate the…

A: Given  Few parameters of a Dc shunt motor.we need to calculate the efficiency of the motor. Please…

Q: Please solve the current I1 in the given circuit using Thevenin's Theorem

A: The given circuit is as shown below,

Q: What is the base current in the given circuit in figure

A:

Q: Q2) Determine the back e.m.f at this load of series motor has a series field resistance of (0.301 2)…

A:

Q: The output of the 3-phase, 425 V induction motor is 18 kW and operates at power factor of 0.65…

A: Given data: Output power, P0=18 kW Power factor, cosϕ=0.65Efficiency=83%

Q: Determine the values of v₁.V₂. and v3. + 24 V Disregard negative sign. V1 = V2 V 12 V 10 V M

A: given here an electrical circuit and asked to determine the V1 , V2 , V3 .

Q: Vs IT + 10 Ω Μ 100/60° Vms ZT -j15 Ω ΣΩ Figure 1 j20 Ω 52 -j5 Ω

A:

Q: What is the equivalent resistance of the combination of resistors shown below: R₂ = 3.5/ R₂ = 2.5 R₁…

A: In this question,  We need to determine the equivalent resistance of the combination of the…

Q: 2) What are the salient features of supply voltage control method? Speed control three phase…

A: 2) salient features of supply voltage control method Supply voltage control method is the speed…

Q: (a) U Let x[n] = {1, 2, 0, 0, 4). What is the energy in x[n]?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: nt compound generator deliver a s a shunt field resistance of 190 of 0.52 and the armature resistal

A: Given as, load current IL=50 A Voltage V=380 V shunt field resistance Rsh=190 Ω series field…

Q: 1. What is the magnitude of the electric field at a point 30cm from a point charge q=2nC?

A:

Q: Use the routh's criterion to test the stability of the system with the following characteristic…

A: Routh’s criterion: Is says that if there are change in the sign (positive or negative) in the first…

Q: 7. What is the minimum conductor ampacity, overload protection, and dual-element fuse rating for a…

A: Given information about a 3-phase motor is, Supply voltage VL=560 Volts. Rated output power Po=125…

Q: A silicon photodiode has a responsivity of 0.6 A/W at a wavelength of 850 nm. Determine the minimum…

A: The Photodiode is a type of semiconductor diode which can convert the light signals into electrical…

Q: 3. Given the information appearing in Fig. 4.120, determine:

A:

Q: Find the power dissipated in the resistance 7 ohm by using sources transformation

A:

Q: s to the nearest integer.

A: Current: I=dqdt Heat: H = I2Rt

Q: An earth electrode consisting of a round section metal pipe of 15 mm diameter is driven in to ground…

A: Earth electrode is a material used for earthing, it can be any conductor buried in the ground.

Q: Find the polarization within a material which has D = 2.8 µC/m² and X e = 1.7

A:

Q: Polyphase Circuits 749 small which is equally deterimental to some types of electrical equipment.…

A: Current: It is the time rate of the change of the charges. It flows from high voltage to low voltage…

Q: find Vth and Rth 8212 5032 5v M M. 330-2 M 30

A: Given here a electrical circuit and asked to determine the Rth , Vth along open circuited terrminals

Q: Convert State space into Transfer Function

A:

Q: Design a stepped-impedance low-pass filter having a cutoff frequency of 3 GHz and a fifth-order 0.5…

A: Given Ro=50ohms, Zi=15ohms , Zh=120ohms cut off frequency= 3 GHz

Q: 6. A 300 kVA, single-phase transformer is designed to have a resistance of 1-5 % and maximum…

A: In this question we need to find a efficiency of transformer at given loading conditions.

Q: A balanced load of 30 MW is supplied at 132 kV, 50 Hz and 0-85 p.f. lagging by means of a…

A:

Q: A rectilinear potentiometer was tested with its slider arm moving horizontally. If this…

A: The damped natural frequency is the frequency at which the system comes to equilibrium. The system…

Q: Q1/ The following information is given for a 250-kW, 500-V, long-shunt compound generator : Shunt…

A: The terminal voltage of the generator is 500 V The power produced is 250 kW The armature resistance…

Q: G(s) = 1 0.01 s+1

A: The transfer system is,  G(s)=10.01s+1G(s)=1×1000.01s+1×100G(s)=100s+100 The bode plot is determined…

Q: Q1. a) Figure 1 shows voltage (magnitude), current (magnitude) and real power measured at the source…

A: Given:V=(1000+XY) =(1000+54)=1054VI=50A

Q: Q3/ Explain and drive the equations of compound generators

A: Compound generator : In compound generators both series and shunt field windings are present one of…