Given a cylindrical Cu bar (length L = 4 m, radius, r = 2 cm). One end is kept in a heat bath at 105 °C and the other temperature at 5 °C. The surface of the bar is insulated so that there is negligible heat loss through it. thermal conductivity of copper: kcu = 385 W/m K Calculate the following up to three (3) significant figures: ) Thermal resistance Rth of the Cu bar, Ans = in K/W

Given a cylindrical Cu bar (length L = 4 m, radius, r = 2 cm). One end is kept in a heat bath at 105 °C and the other temperature at 5 °C. The surface of the bar is insulated so that there is negligible heat loss through it. thermal conductivity of copper: kcu = 385 W/m K Calculate the following up to three (3) significant figures: ) Thermal resistance Rth of the Cu bar, Ans = in K/W

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter1: Temperature And Heat

Section: Chapter Questions

Problem 96P: A warms transfers energy by conduction through its blubber at the rate of 150 W when immersed in ...

See similar textbooks

Similar questions

A warms transfers energy by conduction through its blubber at the rate of 150 W when immersed in 1.00 water. The walrus's internal core temperature is 37.0 and it has a surface area of 2.00 m2. What is the average thickness of its blubber, which has the conductivity of fatty tissues without blood?
Given a cylindrical Cu bar (length L = 4 m, radius, r = 2 cm). One end is kept in a heat bath at 105 °C and the other temperature at 5 °C. The surface of the bar is insulated so that there is negligible heat loss through it. thermal conductivity of copper: kcu = 385 W/m K Calculate the following up to three (3) significant figures: (1) Thermal resistance Rth of the Cu bar, Ans = (2) Conduction heat current Hc, Ans = in W in K/W
units in the heat absorption from the outside air. (b) 36,000 Btu/h Answers: (a) 9.43 hp, cdmppun
A walrus transfers energy by conduction through its blubber at the rate of 150 W when immersed in -1.00C water. The walrus’s internal core temperature is 37.0C, and it has a surface area of 2.00m. What is the average thickness of its blubber, which has the conductivity of fatty tissues without blood?
In order not to damage the resistance in the kettles, the difference between the temperature ofthe heater and the fluid should not exceed 25 oC. If the heat transfer area between the fluid andthe heater is 78.5 cm2 and the heat transfer coefficient is 400 W/m2.K, find the maximumallowable power of the heater in order to boil water?
(a) The data listed in the following table gives hourly measurements of heat flux q (W/m²) at the surface of a solar collector. As an engineer, you estimated the total heat absorbed by a 4 m collector panel during a 13-hr period as h =122.39 W. The panel has an absorption efficiency eab of 45%. If the total heat absorbed is given by h = eab q A dt where A = area and q = heat flux, find K. t 0 1 3 4 5 7 9 11 13 0.10 4.32 5.14 6.05 7.73 K 7.23 5.20 3.38 0.20
A 2.44 m wide by 1.15 m high metal plate must be insulated to prevent contact burn injuries. If the heat transfer rate is 125 W and the temperature across the insulation must be reduced from 88.3°C to 40.7°C, what is the minimum thickness (in cm) of insulation required [round your final answer to two decimal places]? {kins = 0.035 W/m-K} Insulation Н W L
Speaio ieat (calipC) Sutstance Themal Conductivity (cais cmC) Water 1.000 0.215 a092 0 108 0.0018 Copper Iron 0.9200 Based on the specite n's of copper and akmnon nnst of the foloang Statements is rue for equal masses of the tee metats? (A) Copper w heat laster than atuminum (8) Akimum wd neat faster than copper (CA Both e regure the same amount Dfreal to nrease their temperatures by the sane amourit (D) ToncTERSO the tenperature by tme same amount copper require more meat tman alumnum 2. C, or DJs your ansuer in the given respense
Estimate @ Thermal conductivity of Air at 120latm and (140) 'F ? Ch8 72.8 (atm) ?
A walrus transfers energy by conduction through its blubber at the rate of 150 W when immersed in −1.00ºC water. The walrus’s internal core temperature is 37.0ºC , and it has a surface area of 2.00 m2 . What is the average thickness of its blubber, which has the conductivity of fattytissues without blood?
Qs: In iron whose base plaet is mad aluminum alloy is turn on : The time for the plate temperature to reach 140°C. Determine the plate temperature which is to be uniform at all times . Take for the aluminum p-2770 kg/m, C,-875 kJ/kg."C, o=7.3 m'/s. The thermal conductivity of the plate k=177 W/m.°C Air 22°C Ans : 51.8 °C IRON 1000 W 11t t t
At winter design conditions, a house is projected to lose heat at a rate of 60,000 Btu/h. The internal heat gain from people, lights, and appliances is estimated to be 6000 Btu/h. If this house is to be heated by electric resistance heaters, determine the required rated power of these heaters in kW to maintain the house at constant temperature.