For a cylindrical-rotor synchronous machine, the magnitude of the internal generated voltage is |Eg| = 240 volts, and the magnitude of the terminal voltage is |Vt| = 200 volts. Which of the following is true? a. The machine is operating as a generator. b. The machine is operating as a motor. C. Information is insufficient to determine the operating mode of this machine.

For a cylindrical-rotor synchronous machine, the magnitude of the internal generated voltage is |Eg| = 240 volts, and the magnitude of the terminal voltage is |Vt| = 200 volts. Which of the following is true? a. The machine is operating as a generator. b. The machine is operating as a motor. C. Information is insufficient to determine the operating mode of this machine.

Electrical Transformers and Rotating Machines

4th Edition

ISBN:9781305494817

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Motor Maintenance And Troubleshooting

Section: Chapter Questions

Problem 7RQ

See similar textbooks

Similar questions

In speed coontrol of dc motor, the final control element is motor. Select one: O True False
The supply frequency is 50 Hz. What will be the rotor voltage frequency if the motor speed is equal to 90% of synchronous speed. O 45 Hz. O 10 Hz. 05 Hz. O None.
A. Incident sound waves in a dynamic pickup or microphone lead to the passage of AF current in the coil because- 1) The coil's motion within a magnetic field. 2) The motion within an electrostatic field.3) A DC voltage is applied to the coil. 4) Changes in the capacitive reactance across the coil. B. An intermittent (as opposed to continuous) motor is one in which the shaft revolves in- 1) An incremental motor. 2) A stepper motor. 3) A selsyn. 4) A fractional motor.
5 position and 2-way type of ports DCV could be used in the double acting actuator circuit. Select one: True False
* ?In a dc machine ó pole wave winding is used. The number of parallel paths are 6 4
Q1 ---- - Reduce the combinational logic circuit in figure 1 to minimum form. Figure 1 B C D
QUESTION 8 Consider the equations of motion of an armature controlled DC motor given by Jw(t)+bw (t) Ki(t) = -Tfriction - Tload (t) di (t) + Ri (t) + Kw (t) = Vin (t), dt where vin(t) is the input voltage and Tload(t) is the input load torque. The outputs are the armature current i(t) and the motor speed w(t). The steady-state response of motors are specified by nominal voltage, stall torque, stall current, no load speed, and no load current. At steady-state operation, the motor equations satisfy bo) -Ki =-T -T. fric load Ri +Kov_- 55 55 The stall torque is the load torque required stead-state speed of the motor is zero. The stall current is the armature current when the motor speed is zero. The no load speed is the speed of motor when the load torque is zero. The no load current is the current when the load torque is zero. What is stall torque for this motor in N-m? Keep 3 significant figures, and do not include units. Use Scientific notation. The constants are given below. Nominal…
What are the two forcing frequencies?
Why is it necessary to pick between the commutator bars of DC machines?
in a dc machine 72 number of coils are used. Find the number of commutator ?segments required 74 72 37 36
Define motor
4 mechanical Obtuin a two-port formulation for the following wecksricd system: Ez منے اہم 77777 d & fo