A potentiometer with a uniform resistamce per unit length of track has a total resistance of 2 k2 and a supply voltage of 10 V is connected across it. The output from the potentiometer is connected across a load of resistance 5 k2. What will be the error due to this loading when the slider is at the mid-point of the potentiometer track?

A potentiometer with a uniform resistamce per unit length of track has a total resistance of 2 k2 and a supply voltage of 10 V is connected across it. The output from the potentiometer is connected across a load of resistance 5 k2. What will be the error due to this loading when the slider is at the mid-point of the potentiometer track?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

multirange ammeter was designed using direct method to give three scales with Rsh1= 0.001285989 0, Rsh2=0.000562552 0, and Rsh3=0.000100001 Q. The d'Arsonval meter has Rm=6 Q and full scale current of 1.5 mA. Find the ranges.? 8 (Ctrl) -
An AC ammeter is connected in series with the primary winding of T1. What is the expected current reading? An AC ammeter is connected in series with the secondary winding of T1. What is the expected current reading? An AC ammeter is connected in series with R1. What is the expected current reading? NOTE: Idc for HW rectifier = 0.318 * Ipeak = 0.45 * Irms Describe/Explain briefly the purpose/use of the array (series-parallel) connection of the rectifier diodes in the given circuit.
For the circuit below, determine the resistor voltage. The source is 6 volts, the Zener potential is 5.1 volts and the resistor is 1k.
Need help with finding paramters
What is KCL LAW in electrical engineering
PMMC type meter has a full scale deflection of 10 mA. The resistance of the coil is 30 ohm So, (1) Value of shunt for ammeter of 50 A range and (2) Find the value of series resistance required for the range up to 500 V.
A linear resistance potentiometer is 50 mm long and is uniformly wound with wire having a resistance of 10000 ohm. Under normal conditions, the slider is at the centre of the potentiometer. Find the linear displacement when the resistance of the potentiometer as measured by a Wheatstone bridge for two cases is (1) 3520 ohm (2) 8250 ohm .
A snubber circuit has snubber time constant (10 msec), voltage source (10 kV), discharge current of the Thyristor (5 µA) and frequency (50 Hz). Find the rate of voltage changing with time and snubber circuit power losses?
topic: Resistance and ohms law
How temperature effect conductivity? Explain with the help of following equation. m e'n7'
DETERMINE AND LABEL THE LOOPS. Solve the missing values of electric currents using Kirchhoff's laws. FInd the value of electric current flowing in and out of junction b
For the circuit in figure #2, explain how it works and how JFET works on it.