a) Use the node-voltage method to find the branch currents i1, i2, and is in the circuit in Fig. P4.23. b) Check your solution for i₁, i2, and i3 by showing that the power dissipated in the circuit equals the power developed. -sbon ont seU (S CLA Figure P4.23 totius 2008 TUMA SNBIZAR 1 knd bar (d ΚΩ $1.29.01 30 V + + 5 ΚΩ www i₁ 12. 10 mA 500 Ω 4 ΚΩ 13, 80 V

Q: The voltage and current of a load are v(t)-5cos(5xt-15) and 1(t)=0.5cos(5at+15), respectively. Is it…

A: Given data, Voltage,  vt=5cos5πt-15°it=0.5cos5πt+15°

Q: Solve the question by hand do not using computer, explain each step please Example 3.8: ELECTRIC…

A: Note As polarity of current and voltage is not given. I solved this question by assuming the…

Q: 5. Write down the equations of a single phase transformer at no-load mode. Give the names of the…

A: Transformer is a static device which is used to step up or down the voltage level or current level.…

Q: A sinusoidal current is in phase with the voltage. It has an active power of 50 VARS and reactive…

A: Apparent power consist of active and reactive power both. Formula to calculate apparent power is:…

Q: Numerical 2 run-off is been a minimu broje estimated that approximately a4 m²/ sec

A: Active Power- It is power utilized by the load. Reactive power- It is the power which remains within…

Q: Hi please calculate for the CMRR (measured) with resistor values: R1 = 995 Ohms R2 = 100.8 kOhms…

A: Given the circuit, as shown below: R1 = 995 Ω R2 = 100.8 kΩ R3 = 1003 Ω R4 = 99.7 kΩ We need to…

Q: Determine i, in the circuit below

A: Given: Y=0 Required: i0

Q: The magnetic Frame shown is built up of iron of square cross-section, 3cm side. Each air gap is 2mm…

A: In magnetic circuit is the molecular poles and aligned and flux does not flow but in magnetic…

Q: Using Bio-Savart law, calculate the Magnetic Field (B) at an axial point P a distance x from the…

A:

Q: function Draw the direct form block-diagram representation for the casual LTI system with system s+1…

A: Given: Hs=s+1s2+4s+4 Required: Direct form block-diagram representation for the given causal LTI…

Q: Find the potential at the point K due to the point charge of Q placed at the point P. T=3,1416 9 co=…

A: In the above given question we need to calculate the value of voltage at the point K  due to charge…

Q: Find the Thevenin equivalent at terminals a-b of the circuit 492 ww 1.51, 2/0° A -j3 92

A: For the given circuit diagram we need to derive the values of thevenin voltage and impedance.

Q: Referring to this figure, calculate Av if yos= 20 µS. Vp in the figure is Vgs(off)

A: The required parameters can be calculated by using the DC analysis and AC analysis of FET amplifier.

Q: Using mesh analysis, determine the currents for the network of fig (5) 652 SA 6 A w 202 852 ww

A: Given circuit :

Q: ) It takes 1 hour to transmit a file of size 50 Mbyte, find the bit rate and interval. Also, if in…

A:

Q: Question 12 An alternator has 6 poles. At what speed must it be driven to develop 120 cycles? 2400…

A: Given:Pole, P=6Cycle, f=120

Q: Plot & Root locus for the T.f. k G(s)H(s) =+ S(S+1) (5+2) (5+3)

A: 1-Root locus is the locus of The poles of closed loop system when the gain of the open loop system…

Q: When a wire is stretched and its radius becomes r /2 then its resistance will be

A: Given: When a wire is stretched and its radius becomes r /2

Q: 2. Convert each decimal fraction to binary using the sum-of-weights method: (a) 0.32 (b) 0.246 (c)…

A:

Q: Write the state-space representation of the given circuit

A:

Q: 3. If a transmission line with an impedance characteristic of 50 ohm is connected to a load with an…

A:

Q: Two bulbs in series have the following ratings: Bulb1(59W,110V); Bulb2(42W,110V). Find the voltage…

A: In this question we will find voltage across bulb 1 when they are connected in series....

Q: The average value of a sinusoidal current is 300A. What is it’s rms value? Group of answer choices…

A:

Q: 2. For the circuit shown below, calculate: a) The gain (G) of the amplifier associated with the 1.5…

A:

Q: Theveni'ns theorem is not applicable when: 1) Load is coupled with the network 2) Linear 3) Time…

A: Thevenin’s theorem : It is possible to simplify any linear complex circuit, to an equivalent circuit…

Q: (a) Figure 2.1 shows the circuit of a silicon transistor amplifier. The amplifier is to have an…

A:

Q: The conductivity of the material given below is o S/m. Find the resistance between the shaded…

A:

Q: Q2: For the combination configuration in Fig.2. 1. Determine the level of Vpif Ipss = = 6mA, B =…

A:

Q: What do you mean by fractional sampling rate conversion? Explain with an example of converting 48…

A: Sample rate converter is the change stream of discrete sample from another different sample rate. In…

Q: A load of 10 MW operating at a power factor of 0.5 lagging is connected to a 400 V, 60 Hz source.…

A:

Q: The voltage and current of a load are v(t)=5cos(5xt-15) and i(t)=0.5cos(5at+15), respectively. Is it…

A:

Q: 1. A supply voltage of 200 V is connected across the terminal AB in the circuit shown in Figure1,…

A:

Q: R₁ www Ro Re 3 R₂ b

A:

Q: Design a synchronous down counter which will count from binary 15 to 0. Use J-K Flip Flop to design…

A: Design a synchronous down counter which will count from binary 15 to 0. Use J-K Flip Flop to design…

Q: Exercise #4 - MOSFET Bias The following circuit is used to bias an NMOS type MOSFET transistor. In…

A:

Q: (3) A DM system is tested with 10kHz sinusoidal, 1V peak to peak, at the input. The signal is…

A:

Q: 2. For the circuit shown below, calculate: a) The gain (G) of the amplifier associated with the 1.5…

A: For the above given operational amplifier circuit we need to derive gain and voltage VX.

Q: Explain how a full-wave rectifier using center-tapped transformer works. Please include the…

A: For the above given question we need to explain full rectifier with having center tapping…

Q: homework A Junction FET has Y = 50, when VGS =0 what Vos at point where ID becomes DS Constant ?

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: and adjusted for maximum power transfer. Find the maximums Power 2

A: First we need to find the Z-parameters of the given two port network. After we will calculate the…

Q: Question 5: Determine the z-transform of the following signals. (a) x(n) = {2,1,2,2,0,0, — 1,4,7},…

A:

Q: Problem 2 Given: f(W,X,Y,Z) = Σm(4,5,7,9,10,15) + Ed(2,6,11,13) In consideration with the most…

A: For the above given question we need to simplify the given minterms and don't care terms by using k…

Q: A Certain JFET VGS(off) 1

A: FET ( field-effect transistor)-This has three terminals source gate and drain. It is a current…

Q: Use msseh naalyiss to answer the following W=5 Y=0

A: For the above circuit diagram we need to calculate the value of current Io.  In the solution we have…

Q: Calculate the value of the vector current density in cylindrical coordinates at PB(1.5, 90°, 0.5) 2…

A:

Q: For the circuit shown: 1. Find the value of "Rc" that makes the circuit in resonance. 2. Calculate…

A: Given Data:- Voltage(VT)=10∠0°VResistance(RL)=8ΩInductance(XL)=j6ΩCapacitance(XC)=-j5Ω

Q: An alternator has 6 poles. At what speed must it be driven to develop 120 cycles? Group of answer…

A: In this question we will find speed of given machine.....

Q: Given that the electric field E has a triangular profile as shown in the figure below, and that the…

A: For the given electric field plot we need to derive the expression for built in potential.

Q: Referring to this figure, calculate Av if yos = 20 µS.

A: It is given that: yos=20μS

Q: The minimum sampling period of the signal m(t)=5cos(300πt)cos(500πt)is

A: