Which of the following describes why the same guest room on the 10th floor costs more than one on the first floor? Question 7 options: a) Floor superiority b) Set rate type c) Length of stay d) Blackout dates

Which of the following describes why the same guest room on the 10th floor costs more than one on the first floor? Question 7 options: a) Floor superiority b) Set rate type c) Length of stay d) Blackout dates

Residential Construction Academy: House Wiring (MindTap Course List)

4th Edition

ISBN:9781285852225

Author:Gregory W Fletcher

Publisher:Gregory W Fletcher

Chapter7: Introduction To Residential Service Entrances

Section: Chapter Questions

Problem 25RQ

See similar textbooks

Related questions

Q: Calculate the force in HE. Assume tension = positive. Given information repeated for your…

Q: 250m -200 288 Yoo 250 -200 What is the shear load V and moment M at J?

Q: Problem 4. Calculate the moments of inertia of the given built-up section with respect to the x- and…

A: A composite crossection is given as follows

Q: A uniform horizontal beam is simply supported at it's left end x=0 but fixed at the other end X=L as…

A: A propped cantibeam is given with hinged end support.

Q: You are watching a new bridge being built near your house. You notice during the construction that…

A: Given dat - Li =220 mTemprature difference = 21°C Find out -The height to which the spans rise when…

Q: Q3. according to the data of water depths in figure below that collected in the cans test find: - 1-…

A: By deducting the minimum water level from the highest water depth and dividing the result by the…

Q: When there is no difference between two groups, then the value of hazard ratio is 0. True False

A: False.The risk of an event occurring between two groups at any given time is compared using the…

Q: Grades of g₁ = -2.50% and 9₂= +1.50 %, VPI elevation 856.00 ft at station 22 +00, and a fixed…

A: .Field conditions require a highway curve to pass through a fixed point Compute a suitable…

Q: Calculate the moment of inertia with respect to the y axis of the shaded region of the area shown…

Q: The mean stress at a point in a rock is 60 MPa, and the Deviatoric Stress is 27.5 MPa. Calculate the…

Q: Sample Problem 3: A lap joint shown is bolted with an A325 bolts having a diameter of 22 mm and A572…

Q: thank you much. And if I need to calculate the loads on the piles under column C3 and select a…

A: For this problem, we have to find out design for column C-3

Q: Allowable stresses: Tension of plates = 138 MPa Bearing of rivets = 220 MPa Shearing of rivets = 112…

Q: Determine the force in members CE, CF and BF for the truss loaded as shown. Ans. BF = 0.289P (T) BO…

Q: Homework 13: Draw the complete shear and bending moment diagrams. Show coordinates at key points and…

Q: 1. Locate the x-coordinate of the centroid, , of the shaded area, relative to the origin. Put your…

Q: Select the value of Cs to use for the edge of a 2'x20' flexible strip footing. Table 7-1 Values of…

A: cs values for different foudations are given as followscs value for flexible strip footing of…

Q: 2. Rate constant in the BOD test is depend on 1. 2. 3.

A: We need to write factors on which rate constant in BOD test depends.

Q: Q6/The average monthly inflow for a niver are shown in the table below. A-Draw Slow duration curve…

Q: 2. For the hollow box reinforced concrete beam of detail shown in Figure. Answer the following: 1-…

Q: 2. The strength of soil is a. the total stress at failure the effective stress at failure c. the…

A: strength of soil is known as?

Q: me beam shown ists of a 200 GPa; /= 1120 × 106 mm4]. If w= 66 kN/m and P= 128 kN, determine: AY, V P…

A: The beam shown in Figure Q.2 consists of a W610 × 140 structural steel wide-flange shape [E = 200…

Q: What are the possible Introductions to SDGs or Sustainable Development Goals in your own words?

Q: The liquid in the figure has a specific gravity of 3.00. The gage pressure P₁ =700 KPA and PB is…

Q: When a large load present above a clay layer is removed before new construction begins above the…

A: When a large load present above a clay layer is removed before new construction begins above the…

Q: Construction of a new building founded on a clay while was completed in January 2010 in January…

Q: The pressure at point m is increased from 70 KPa to 105 KPa. This causes the top level of mercury to…

A: The pressure at point m is increased from 70 kPa to 105 kPa, The mercury level rises by 20 cm in the…

Q: The mean stress at a point in a rock is 60 MPa, and the Deviatoric Stress is 27.5 MPa. Calculate the…

Q: H.W 1- The floor beam in Fig. below supports nonstructural elements not likely to be damaged by…

A: Given,Live Load, L.L. = 21 kN/mService Load, S.L. = 12 kN/mfc' = 25 MPafy= 400 Mpa

Q: Part A At the instant the spring becomes undeformed, the center of the 43 kg disk has a speed of 4…

A: m=43 kgV= 4 m/sk= 200 N/mr= 0.3 mTo find:calculation of distance

Q: 4. A confined horizontal aquifer of 20 m thickness and permeability K = 22 m/day, connects two…

Q: Suppose the ski patrol lowers a rescue sled and victim, having a total mass of 90.0 kg, down a 60.0°…

Q: Q3/ Find the flood peak and its time that resulting from three respective storms each of 6hrs…

A: The flood peak is a critical parameter in assessing the severity and potential impact of a flood.A…

Q: B/ Find the diameter of the particles with specific gravity of 1.2 removed in a tank having a…

A: To find the diameter of particles that can be removed in a sedimentation tank, you can use the…

Q: Draw the shear and bending moment diagrams on shown below using Slope-deflection Method. compression…

Q: Bending moment diagram for a overhanged beam is shown in figure. [Consider the supports at B and D]…

Q: A student conducted 2 UU triaxial tests on Kaolin clay samples in the laboratory. Table 1 provides…

Q: Consider a sample of water contaminated with organic pollution represented by an equivalent sugar…

A: Equivalent sugar concentration of 52 mg/L Theoretical Oxygen Demand = ?

Q: a. Derive a 2-hour Unit Hydrograph for a Watershed Area of 2600 acres. The total 2 hour rainfall was…

A: Watershed area = 2600 acres2 hr rainfall = 6 inrunoff for first two hours = 0.8 in = 2.032…

Q: A tube well having a diameter 15 cm fully penetrates a confined aquifer of thickness 10 m. The…

A: Radius of influence, Diameter of tube well, Discharge,

Q: The answers are wrong and I would like them in three decimal places in mm

Q: Define air pollution sources * What is the most common source of carbon emissions in American…

A: We need to define air pollution sources and discuss most common source of carbon emissions in…

Q: Draw Shear and Bending moment diagrams for the frame shown below using Force Method and virtual work…

A: Given:Required:Shear force and bending moment diagram

Q: Draw isometric details of one isometric drawing -concrete to metal connection,drywall…

A: Draw a isometric details of following:-concrete to metal connection -dry wall partition -ceiling…

Q: A bolted connection shown in figure 3.27 is made up of 150 x 87.5 x 9.5 mm. The angle is made of…

Q: 4. A site is underlain by a normally consolidated, saturated soil layer with thickness = 8m. The…

A: Normally consolidated soil thickness = 8m Soil layer rests on bedrock Lateral stress ratio = 0.5…

Q: A 20 m long concrete pile is shown in Figure P12.2. Estimate the ultimate point load Q,, by a.…

A: we have to answer part a and part c only Concrete pile :Reinforced cement concrete piles are a…

Q: 4. The cantilever beam AB is of uniform cross section and its load is shown in figure 4. El for beam…

Q: The two constraints on resource allocation are Budget and time Cost and resource Scarce resource and…

A: 1) Budget and Time:Budget dictates how much can be spent, but doesn't directly impact…

Q: a) Locate the X' centroidal axes for the areas shown with the respect to the reference axis shown…

Concept explainers

Electrical Plans

An electrical plan is also known as an electrical drawing or a wiring diagram. It is a kind of visual representation which bears the blueprint symbols of all the electrical components in electrical house plans or various building construction projects. In other words, electrical plans describe electrical circuits and systems that build up the electrical house plans or building plans. An electrical engineer who works on various construction projects creates an electrical drawing. The engineer outlines the electric planning with different symbols and lines forming a detailed electrical circuit. These drawings are a means of representation for the clients, who will carry out the actual wiring process. In a nutshell, an electrical plan showcases the circuitry with the proper placement of electric components.

Question

Which of the following describes why the same guest room on the 10^th floor costs more than one on the first floor?

Question 7 options:

a)	Floor superiority

b)	Set rate type

c)	Length of stay

d)	Blackout dates

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given

VIEW

Step 2: Choose correct option

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The minimum number of plumbing fixtures required for a restaurant planned for 250 seat. Assume 50% for each gender.
6. Determine the minimum number of plumbing fixtures required for an auditorium planned for a total of 5500 people (assume 50% of each gender).
The minimum number of plumbing facilities required for an auditorium planned for a total 0f 5,500 people. Assume 50% for each gender.
Please provide detailed information about the usage classes of the buildings and the regulations regarding fire risks.
A basic : dwelling form provides coverage for which of the following perils? Theft Glass breakage lightening water backup
Pipe flow question.
D only, thanks
please answer no 3 only, thanks.
We are designing an office building with 200 feet height zone. From occupancyclassification and use’s table find the following: Does the code require stair shaft ventilation? Does the code require single-station smoke detector? Does the code require corridor door equipped with self‐closing devices? Use 2007 California Building Codes (CBC) to find the answers and post them.
4. A facility is to house 40 female and 50 male employees. Using a 40% allowance for aisles and clearances, how much space should be planned for the restrooms? 5. If three nurses, one full-time and one part-time physicians are to be employed in a health service area, how much space should be allowed in the facilities plan?
With complete solution, Thank Youuuuu!
Please answer question no 2 and 3 only, thanks.