The parallel plates have an area of 2000 cm2 and are separated at 1.00 cm apart. The original potential difference between them is 3000 V and it decreased to 1000 V when a sheet of dielectric was inserted. What is the; (a) Original capacitance (b) The magnitude of the charge on each plate (c) Capacitance Cafter dielectric is inserted (d) Dielectric constant K (e) Permittivity of dielectric (f) The magnitude of induced charge (g) Original electric field

The parallel plates have an area of 2000 cm2 and are separated at 1.00 cm apart. The original potential difference between them is 3000 V and it decreased to 1000 V when a sheet of dielectric was inserted. What is the; (a) Original capacitance (b) The magnitude of the charge on each plate (c) Capacitance Cafter dielectric is inserted (d) Dielectric constant K (e) Permittivity of dielectric (f) The magnitude of induced charge (g) Original electric field

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3RQ: A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted...

See similar textbooks

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
In a pure capacitive circuit, does the current lead or lag the voltage?
In reference to the load, how are capacitors connected to help prevent voltage spikes and surges? Are capacitors connected in parallel or in series with the load?
8. Liquids with solid impurities a) Have higher dielectric strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average de voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35
Problem 1301 A-capacitor whose plates is 20 cm x 3.0 cm and is separated by a 1.0-mm air gap is connected across a 12-V battery. Determine the charge accumulated on each plate after a long time. A. 5.3 x 10-12 c B. 7.2 x 10-C C. 8.1x 10-11 c D. 6.4 x 10-10 C
What will happen to the value of the current if the capacitance will be increased or decreased? Explain further
What is the maximum voltage come across in capacitance
Each of the conductor in a parallel-plate capacitor is calleda. dielectricb. insulatorc. platesd. terminal
a)For the inductive element of Figure 1 , the current in phasor form is B) the voltage in phasor form for figure 1 is C)the impedance of the inductor for figure 1 is
The maximum efficiency for pure inductance load and iron-losses = cupper losses is zero. O True O False
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
Find loss tangent and dielectric constant