Station 5 Make a 0.500M sodium hydroxide solution Procedure: 1. Add 15 mL of distilled water to a 50 mL beaker 2. Weigh out 0.500 g sodiurn hydroxide pellets. 3. Slowly add the sodium hydroxide pellets to the water. 4. Calculate the molarity of the sodium hydroxide solution. 5. Show instructor calculation for molarity before moving on to step 5.

Station 5 Make a 0.500M sodium hydroxide solution Procedure: 1. Add 15 mL of distilled water to a 50 mL beaker 2. Weigh out 0.500 g sodiurn hydroxide pellets. 3. Slowly add the sodium hydroxide pellets to the water. 4. Calculate the molarity of the sodium hydroxide solution. 5. Show instructor calculation for molarity before moving on to step 5.

Chemistry: Principles and Reactions

8th Edition

ISBN:9781305079373

Author:William L. Masterton, Cecile N. Hurley

Publisher:William L. Masterton, Cecile N. Hurley

Chapter10: Solutions

Section: Chapter Questions

Problem 12QAP

See similar textbooks

Similar questions

Graph Table 14.10 shows solubility data that was collectedin an experiment. Plot a graph of the molarity ofKI versus temperature. What is the solubility of KI at55°C?
What happens if you add a very small amount of solid salt (NaCl) to each beaker described below? Include a statement comparing the amount of solid eventually found in the beaker with the amount you added: a a beaker containing saturated NaCl solution, b a beaker with unsaturated NaCl solution, c a beaker containing supersaturated NaCl solution. A saturated sodium chloride solution.
You make a saturated solution of NaCl at 25 C. No solid is present in the beaker holding the solution. What can be done to increase the amount of dissolved NaCl in this solution? (See Figure 13.11.) (a) Add more solid NaCl. (b) Raise the temperature of the solution. (c) Raise the temperature of the solution, and add some NaCl. (d) Lower the temperature of the solution, and add some NaCl. Figure 13.11 The temperature dependence of the solubility of some ionic compounds in wafer. The solubility of most ionic compounds increases with increasing temperature This is illustrated using NH4CI (ports b and c).
Addition of water to concentrated sulfuric acid is dangerous because it generates enough heat to boil the water, causing it to spatter out of the container. For this reason, chemists remember to add acid to water. In a dilution experiment, we calculate the amount of the more concentrated solution that must be measured out. If we place this concentrated solution (Figure 4.7) in the volumetric flask first, then dilute with water, we violate the caution Add acid to water. Describe a safer variation on the method shown in Figure 4.7 that allows the quantitative dilution of concentrated sulfuric acid. Figure 4.7 Preparing a dilute solution from a concentrated solution. (a) Draw the concentrated solution into a pipet to a level just above the calibration mark. (b) Allow the liquid to settle down to the calibration line. Touch the tip of the pipet to the side of the container to remove any extra liquid. (c) Transfer this solution to a volumetric flask. Again touch the pipet to the wall of the flask to ensure complete transfer, but do not blow out the pipet because it is calibrated for a small amount of liquid to remain in the tip. (d) Dilute to the mark with solvent. Frequently, especially with concentrated acids, it is best to have some solvent present in the volumetric flask before you add the concentrated sample.
Distinguish between dispersion methods and condensation methods for preparing colloidal systems.
Calculate the percent by mass of KBr in a saturated solution of KBr in water at 10 °C. See Figure 11.17 for useful data, and report the computed percentage to one significant digit.