Q5- Adjust a fire angle for a three-phase full-wave semi-controlled converter to feed the separately exciter DC motor to get a load torque can be reached to 750 rpm. When the supply voltage of converter is 150 volts per-phase and the absorbed current through the armature 40A with resistance 0.2 a and a constant back emf 0.4v/rpm. Then find the maximum speed for motor assume the previous parameters values are a constant. "Good Luck"

Q5- Adjust a fire angle for a three-phase full-wave semi-controlled converter to feed the separately exciter DC motor to get a load torque can be reached to 750 rpm. When the supply voltage of converter is 150 volts per-phase and the absorbed current through the armature 40A with resistance 0.2 a and a constant back emf 0.4v/rpm. Then find the maximum speed for motor assume the previous parameters values are a constant. "Good Luck"

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.4P

See similar textbooks

Similar questions

Question 2. Considering this figure. The firing angle is 45°, the motor current is 10 A, and the supply voltage is 110 v. 0₁ 0₂ 90 (a) Draw the waveforms of v, Vo. io. isi, iDi, and i. (b) Determine the power taken by the dc motor. (c) Determine the supply volt-amperes and supply power factor. Assume that the converter is lossless. (d) Determine the rms value of the SCR current and the diode current.
What is use of solenoid coil in the pressure to converter? a. To produce magnetic field in the LVDT b. To change the LVDT output c. To bring back the pivoted beam normal position d. To produce linear displacement in bellows
Does Clampor circuit change the peak-to-peak (i.e., rms value)? Justfy
A field excitation of 20 A in a certain alternator results in an armature current of 400 A in short circuit and a terminal voltage of 2000 V on open circuit. The magnitude of the internal voltage drop within the machine at a load current of 200 A is
A four-pole induction motor drives a load at 2575 rpm. This is to be accomplished by using an electronic converter to convert a 400-V dc source into a set of three-phase ac voltages. ▾ Part A Find the frequency required for the ac voltages assuming that the slip is 4 percent. The load requires 2 hp. Express your answer to three significant figures and include the appropriate units. f= Submit ▾ Part B Value μÀ Submit I= Value Provide Feedback ^ Request Answer If the dc-to-ac converter has a power efficiency of 85 percent and the motor has a power efficiency of 80 percent, estimate the current taken from the dc source. Express your answer to three significant figures and include the appropriate units. 4 Ò Request Answer Units ? Units ?
The winding of a 4-pole alternator having 36 slots and a coil span of 1 to 8 is short-pitched by ........... degrees. 150 40. 90 20 Brushless excitation system consisting of: Stator field winding and power diodes stator and rotor field winding and capacitor stator and rotor field winding and power diodes Everything mentioned in the options Full Name : *
A Flyback converter (for questions 1-3) shown below has the following parameters. Vin=100V, Vo=20v, Po=40W, D=0.25, Fsw=250kHz iin i out in 1. What is the turns ratio N1:N2 between the primary side winding and the secondary side winding? A. Ν1: N25:3 B. N1: N2 = 3:5 C. N1: N2= 5:2 D. None of the above %3D 2. What is the maximum voltage on the power switch? A. 120V В. 133V С. 100V D. None of the above 3. What is the maximum voltage on the diode? Α. 40V В. 133V C. 80V D. None of the above 4. The magnetizing inductor at the primary side winding is 100uH, what is the peak current in the power switch? Α. 1.8Α В. 1.6A С. 2.1A D. None of the above
Maz a) A sinewave is having a frequency of 50 Hz and instantaneous value of 250 Volts at 1.3 milli seconds. Find D The maximum value of sinusoidal voltage waveform and i) The value of voltage at 2.1 milli seconds. b) Determine the instantaneous equation for the voltage waveform shown in figure, if Vp=100 Volts, Time period is 10 milli seconds and 0 =40 degrees. on Vp Upload your Answers steps in the "Final Answer Submission" Link provided in the Moodle. a) (i) Maximnum value = a) (ii) Value of voltage at 2.1 ms = b) Angular frequency =
In a single phase AC capacitor start and run induction motor, to make the rotation in anti-clockwise direction, the capacitor is connected in a. series with running coil b. parallel with starting coil c. series with starting coil d. parallel with running coil
Armature reaction in an alternator affects generated voltage/phase Select one: O True O False
We know there are few conditions for alternator synchronization. How many conditions are there? Write all the conditions.
1. The operation of Commutator in DC Motor is * O a) to convert dc to ac O b) to convert ac to dc O c) to convert fixed dc to variable dc O reverse the current direction in the rotating windings each half turn