Power supply to a 10 pole induction motor is supplied by 4 pole alternator which is driven at 1500 RPM. If the motor runs with slip of 4%, what is the speed?

Q: 5. Find v(t) for t> 0 in the following circuit. Assume the switch has been open for a long time and…

A:

Q: Calculate the gain of a negative feedback amplifier having A = -3000 and beta= -1/100.

A:

Q: Discussion of power quality aspects that need to be considered before installing the power factor…

A: power factor correction aims to improve power factor and therefore power quality. It reduces the…

Q: Find the Thevenin and Norton equivalent circuits between terminals/points (a) and (b) for the…

A:

Q: A 250 V DC shunt generator has a constant loss of 1250 W. Find the load current for maximum…

A: Solution: Given data ; voltage V=250 V, shunt generator ; constant loss =1250 W, armature resistance…

Q: Find and draw the Norton equivalent circuit with respect to the terminals a and b for R₁ the circuit…

A:

Q: Example 3.5 o Evaluate both sides for the field D = 2x yax + rectangular parallelepiped X = 0 and 1…

A:

Q: A 25 KVA transformer supplies a load of 12 KW at a power factor of 0.6 lagging. If additional unity…

A:

Q: a) Show the connection of an LM124 quad op-amp as a three-stage amplifier with gains of -10, +25,…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Vc = -3.50 @ positive half cycle Vo = 8.50 @ negative half cycle Vo = -1.50

A: The clamper circuit is used to Swift the DC line of the input signal based on the diode connection.…

Q: Q1\ Design the electronic circuit to transformation source voltage (220 V-AC) to output voltage (5…

A:

Q: A PV module produces 334 W at 18 °C and 245 W at 45 °C. a) What is the nameplate power? Give your…

A: Given information, A PV module produces P1=334 W power at T1=18°C and P2=245 W power T2=45°C. We…

Q: 3) For a two pole, 50 Hz, 3 phase synchronous motor, the speed of rotating magnetic field is o 1000…

A: Given: A three phase synchronous motor has, Number of poles, P=2. Supply frequency, f=50 Hz.

Q: 1. In what time would a current of 10 A transfer a charge of 50 C? [5 s]

A: Given, Current, i=10 A Charge, q=50 C Time, t=?

Q: What are the advantages of using a PLC-based system over a relay-based system? O There are no real…

A:

Q: Compensator function as

A: Compensator function as specialized filters.

Q: Question 2 Find the average value of the voltage in the figure "inn L V ov+ O 1.59 V O 63.7 V O 6.37…

A: Given data, Waveform is given as, From the waveform peak value of voltage, Vm=5 V

Q: Q- A transmission line has characteristic impedance is 50 and length I = A/8. If load Z₁ = (R+j30),…

A:

Q: 5) Find the Thevenin and Norton equivalent circuits between terminals/points (a) and (b) for the…

A:

Q: Vo below. the given cir ID1 Ge 31.3 V 17.6 V 39.3 V 32 V 31.7 V Si ID2 6.8 kohms 4 V Vo

A:

Q: 7. What is the no-load voltage when the full-load secondary voltage is 108 V and transformer…

A: Given: In a transformer, Full load secondary voltage V2fl=108 V. Transformer regulation VR=10%.

Q: Investigate the stability of the following system (Consider quadratic Lyapunor system) 4 ==G (-1) {…

A:

Q: The real component of one of the two square roots of 5-j12 is a. 3 b. 1 c. 4 d. 2 The answer…

A: The polar form of 5-j12 is 13exp(-67.38j).  The square root of the above polar form is √13…

Q: Sampling at time t = 0, 4, 2x4, 3x4 using ZOH. What's the output at 2.5 seconds? The signal is t^2…

A: Given:  Signal f(t)=t^2 The signal is to be sampled using ZOH method at time instants t=0,4,8,12 We…

Q: A 100 kVA distribution transformer has an iron loss of 2.0 kW and a total load copper loss of 4.5…

A:

Q: -Apply the superposition principle to determine the voltage (V) for network of Fig.3. ature of…

A: It is given that:

Q: In an induction motor, if the rotor is locked, then the rotor frequency of induction motor will be:…

A: Given: In an induction motor, the rotor is locked.

Q: a) Calculate the voltage of the circuit, Vo and the branch current /2, and the resistance R₁. 9 A…

A: Given circuit:

Q: A silicon diode has a maximum allowable junction temperature of 150°C. Find the maximum allowable…

A: Given data, Maximum allowable temperature Tj=1500 C Temperature at which maximum power dissipation…

Q: You are working at a company that manufactures solenoids for industrial and research use. A client…

A: Given, V=1000 Vl=25 cmrs=1.00 cmdω=0.127 mm Determine the maximum magnitude of the magnetic field…

Q: Determine the value of the current passing through a resistance of 8 2 in the network shown in the…

A:

Q: A power station has a maximum demand of 13590 kW. The annual load factor is 60% and plant capacity…

A: We have an power station and the data given about that power factor as below, Maximum Demand = 13590…

Q: 10.25 The three parallel loads in the circuit shown in Fig. P10.25 can be described as follows: Load…

A:

Q: H.W Design 4-bit GPR using as follows SISO Function 00 01 10 1 1 No operation Arithmetic Shift…

A: GIVEN:  SIS0 FUNCTION 0    0 No operation 0    1 shift right 1    0 shift left 1     1…

Q: Referring to Fig. 12.87, we have, 1₁ Z₁ + (1₁ +1₂)Z = E₁ 1₂ *Z₁ + (1₁ +1₂)Z = E₂ and Subtracting eq.…

A:

Q: 1. Determine the frequency-domain representations corresponding to each of the following time-domain…

A:

Q: Two signals m(t) and m₂(t) both band limited to 5 KHz are to be transmitted simultaneously over a…

A: Given:

Q: Solve the output voltage Vo of the given circuit below. ID1 Ge 31.3 V 17.6 V 39.3 V 32 V 31.7 V Si…

A:

Q: 5. If all resistors in the circuit is R ohms, find Rab.

A: We need to find out equivalent resistance between a and b for given circuit

Q: IF apc = 0.99, Ic = 6 mA and IcBo = 15 μA, what is the value of Ig? 1. 45 μα 2. 55 ΜΑ 3. 50 μα 4. 60…

A: Given: In a transistor, αDC=0.99,IC=6 mA,ICB0=15 μA.

Q: Draw a PLA circuit to implement the functionsF1=A′B+AC+A′BC′ F2=(AC+AB+BC)′

A: Given two functions F1 and F2. F1=A′B+AC+A′BC′ F2=(AC+AB+BC)' Draw the PLA circuit.

Q: An airfield rectangular wavelength of inside dimensions 7cm X 3.5 cm operates at dominant mode of…

A: Given dimensions, 7 cm×3.5 cm

Q: 1.You are synthesizing a chip composed of some logic with an average activity factor of 0.1. You are…

A:

Q: Consider the figure shown below with all values in mm and the uniform thickness of 20 mm. If the…

A: GIVEN: thickness=20mm              flux density=1T              number of turns of coil=500 FIND:…

Q: SPIELE Rotate Clipboard Shapes 4.16 The resistances of the armature and field windings of a series…

A:

Q: Calculate the gain of a negative feedback amplifier having A = -3000 and beta= -1/100.

A: Given: A negative amplifier has open loop gain, A=-3000. Feedback factor, β=-1100.

Q: 750kW alternators are operated in parallel. P₁ = 750kW, P₂ = 750kW Speed regulation of one machine…

A:

Q: Problem 3.62: Determine the equivalent inductance for each of the series and parallel combinations…

A: Given circuit,

Q: system. Check if the system y(n) = x(-n) is time variant or time invariant

A:

Q: The switch in Fig.4, has been in position a for a long time. At t=0, it moves to position b…

A: In this question we need to find a current i(t) for t>0 in the given circuit.

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.