If the rotor of the receiver in a torque synchro system was prevented from aligning with the transmitter rotor, then ___________. a. a high current will flow in the stator windings b. the transmitter will turn to align with the receiver rotor c. the receiver and transmitter will overheat and produce a hum

If the rotor of the receiver in a torque synchro system was prevented from aligning with the transmitter rotor, then ___________. a. a high current will flow in the stator windings b. the transmitter will turn to align with the receiver rotor c. the receiver and transmitter will overheat and produce a hum

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter42: Synchronous Automatic Motor Starter

Section: Chapter Questions

Problem 9SQ: How does the AC coil of the PFR receive the induced field current without receiving the full field...

See similar textbooks

Similar questions

59. Where is the center of the magnetic field for the single phase shaded pole motor illustrated in Figure 3B when the sine wave in Figure 3A_is at the 45 electrical degree mark? a) center on the unshaded part of the polesb) center on the shaded part of the polesc) center on the whole of both pole facesd) none of the above
A DC machine with 2 poles, wave * winded (retrogressive) (two layers) with 18 slots, the values of pole pitch and *: commutator pitch are a. 9,19 O b. 9,17 O c. 9,18 O
What is the name of the voltage when the field current is zero of the open circuit of the DC generator? a. rated voltage b. Generated EMF c. Back emf d. Residual voltage Clear my choice
How does the AC coil of the PFR receive the induced field current without receiving the full field current strength?
A 8 pole wave wound dc shunt generator runs at a speed of 1450 rpm, has an armature and shunt field resistance of 0.7 Q and 240 Q respectively. The armature has 910 conductors and flux per pole is 0.115 Weber. If the lamp load connected has a resistance of 20 0, determine (i) Generated EMF (ii) Total Resistance (iii) Armature Current (iv) Terminal Voltage.
Q25) i) What are the factors that the induced voltage in three phase induction motor depends upon and Explain how the rotating magnetic field is produced in the three phase induction motor.
(B)-The winding sequence diagram show below for 4 pole d.c generator, 2-layer simplex progressive wave winding, the armature has 17 slots. Determine: (i) The back and front pitches measured in number of slots. b. YPA A (ii) Number of (iii) Number of parallel branches in armature. 5 14 6 15 7 16 8 17 9 1 10 2 11 3 174 13 10 2 11 3 12 14 16 8 17 9 1
The preferred method for applying the field excitation voltage uses a field relay which operates on the principle of A. speed application. B. time application.C. angle application. D. thermal application.
60. Where is the center of the magnetic field for the single phase shaded pole motor illustrated in Figure 4B when the sine wave in Figure 4A is at the 90 electrical degree mark? a) center on the unshaded part of the poles b) center on the shaded part of the poles c) center on the whole of both pole faces d) none of the above
c) What is the physical meaning for each of the following induction motor parameters: R1 „R2 ,Rc ,X1 ,X2 ,Xm ? What is synchronous watt?
In a single phase AC capacitor start and run induction motor, if the capacitor is connected in series with running coil, the motor will __________________. a. rotate in any direction. b. not rotate. c. rotate in anti- lockwise direction. d. rotate in clockwise direction
6. An 8 pole, simplex wave, series generator is wound for 130V, 500 A capacity. It has an armature resistance of 0.05 ohm and is wound in 6 turn per coil , 2 conductor per turn and 12 conductor/slot, slots = 130. Find the new generated emf if the armature is rewound as simplex lap. Rse = 0.02 ohm.