For the system as shown in the following figure, convert the components to same base voltage and apparent power, by choosing 100 kVA as the base KVA and 2000 V as the base voltage for the generators. Redraw the single line diagram with the new per unit values. 15 KVA 2000 V Z=j0.3 pu 25 KVA 2000 V Z=j0.15 pu G1 G2 لمعما 35 kVA 2000/8000 V Z=j0.2 pu Z=30+j100 pu Z=60+j120 pu لعمها لعمها لعمها 35 KVA 8000/2000 V Z=j0.3 pu 35 KVA 2000/8000 V Z=j0.25 pu G3 10 KVA 2000V Z=j0.35 pu M 30 KVA 2000 V

For the system as shown in the following figure, convert the components to same base voltage and apparent power, by choosing 100 kVA as the base KVA and 2000 V as the base voltage for the generators. Redraw the single line diagram with the new per unit values. 15 KVA 2000 V Z=j0.3 pu 25 KVA 2000 V Z=j0.15 pu G1 G2 لمعما 35 kVA 2000/8000 V Z=j0.2 pu Z=30+j100 pu Z=60+j120 pu لعمها لعمها لعمها 35 KVA 8000/2000 V Z=j0.3 pu 35 KVA 2000/8000 V Z=j0.25 pu G3 10 KVA 2000V Z=j0.35 pu M 30 KVA 2000 V

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Similar questions

The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine the pu reactance on a base of 17 KV, 250 MVA. New pu reactance is.......
The reactance of a generator is given as 0.25 per-unit based on the generator’s of 18 kV, 500 MVA. Find its per-unit reactance on a base of 20 kV, 100 MVA. a. 0.0505 b. 0.0605 c. 0.0405 d. 0.0606
In the system shown in Figure 1, the transformers are connected star-star with both star points grounded and the generators are connected in star with thier star points grounded. The system base is 15 MVA. The transformers all have reactances of 0.04 p.u. on this 15 MVA base. The reactances of all other elements are given in Table 1 (in 2) and the voltage levels are given in Table 2. p.u. G1 p.u. T1 jö Per-Unit Convert all values to p.u. on a 15 MVA base. Xa= p.u. Xc₂= XL = V BABE G1 2 X 9 T3 Figure 1: A section of the distribution system T1 L Table 1: Sequence reactances (2) 3 G1 L G2 0.3 0.59 0.01 4 L 9/10 10 Fault Voltage What is the voltage at bus 3 (in Volts) after the fault has occurred? Vp= V T2 5 T2 34 10/4 Table 2: Voltage bases (kV) G2 4 T3 10/9 | G2 Fault Current A three-phase fault with a fault reactance of 0.01 p.u. occurs at bus 3. Calculate the fault current flowing at the fault point in KA. Ip=-j KA So
3 X 0.1 1 2 XL = 0.2 to Eato oto O X = 0.1 X = 0.1 Above is the one-line diagram of a simple power system. Each generator is represented by an emf behind the subtransient reactance. All impedances are expressed in per unit on a common base. All resistances and shunt capacitance are neglected. The generators are operating on no load at their rated voltage with their emfs in phase. A symmetrical fault occurs at bus 1 through a fault impedance Z, =j0.08 per unit. a) Using Thevenin's Theorem, determine the impedance to the point of fault and the fault current in per unit. (2 Marks) b) Find the bus voltages and line currents during the fault. (2 Marks)
For a power station the yearly load duration curve is a straight line from 40,000 to 3000 kw. Tomeet the load three turbogenerators are installed. The capacity of two generators is 16,000 kweach and the 3rd is rated at 6,000 kw. Draw the annual load duration curve and determine the following the Energy generated per year, Load factor and Annual Capacity factor
A generator is having an impedance of 0.93 p.u., before fault occurs in it. What is the possibility of impedance during fault?
Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a circuit having a 60-ohm resistor, 35-?F capacitor, and a 0.25-henry inductor in series. Determine power factor. A. 0.979 C. 0.924 B. 0.862 D. 0.707
A 400 MVA synchronous machine has H, = 4.6 MJ/MVA and a 1200 MVA machine has H₂=3.0 MJ/MVA. The two machines operate in parallel in a power plant. Find out H relative to a 100 MVA base.
In transformers, the flux lost in the air is called nd as SKW. If th
The winding data for three different alternators are as follows 1. 60 slots, four poles, span 1 to 9 II. 120 slots, six poles, span 1 to 16 II. 144 slots, eight poles, span 1 to 11 The windings having a pitch factor less than 0.9 are a. I and II only b. I, Il and III. c. I and II only d. Il and III only
The winding data for three different alternators are as follows I. 60 slots, four poles, span 1 to 9 II. 120 slots, six poles, span 1 to 16 III. 144 slots, eight poles, span 1 to 11 The windings having a pitch factor less than 0.9 are a. II and III only b. I and II only c. I, II and III. d. I and III only
A three-phase 50 MVA 10 kV generator has a reactance of 0.2 pu per phase. Hence the per-unit value of the reactance on a base of 100 MVA 25 kV will be