Differential Equations: Electric CircuitsWhen a resistance R (ohms) and a capacitance C (farads) are connected in series withan emf E (volts), the current I (amperes) is given by the equation:dE1R- +-I =dtCdICdtIf R = 1000 ohms, C = 5x10-4farad.and It = 1 second and E = 100 volts.a. 1.35 amperesb. 2.35 amperesc. 3.35 amperesd. 4.35 amperes10 amperes for t = 0, find the current for

Answered: Image /qna-images/answer/64b0065d-7ae1-4ae2-ad23-2bcc1f631847.jpg

Differential Equations: Electric Circuits When a resistance R (ohms) and a capacitance C (farads) are connected in series with an emf E (volts), the current I (amperes) is given by the equation: dE 1 R-+-I dt C dI dt If R = 1000 ohms, C = 5x10¬4farad.and I t = 1 second and E = 100 volts. 10 amperes fort = 0, find the current for a. 1.35 amperes b. 2.35 amperes c. 3.35 amperes d. 4.35 amperes

Differential Equations: Electric Circuits When a resistance R (ohms) and a capacitance C (farads) are connected in series with an emf E (volts), the current I (amperes) is given by the equation: dE 1 R-+-I dt C dI dt If R = 1000 ohms, C = 5x10¬4farad.and I t = 1 second and E = 100 volts. 10 amperes fort = 0, find the current for a. 1.35 amperes b. 2.35 amperes c. 3.35 amperes d. 4.35 amperes

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

mam/sir how do u draw an electrical circuit, with a voltometer and a anmeter.
During an experiment to verify Ohm's law, the voltage and resistance of a circuit are measured. [Resistance is measured in Ohm (2) and voltage in Volts (V)]. V wwww R + Battery The measured value of the voltage is V = 7.1 + 0.2 V and that of the resistance is R = 11 + 0.3 Q. The current through the circuit (in Ampere (A)) can be calculated using the formula, I =V/R. Calculate the, a) Current (in Ampere) = b) Fractional uncertainty in the current = c) Absolute uncertainty (in Ampere) in the current =
what is the total resistance? Assume that the current enters one coraer and the sides of a cube. exits at the diagonally opposite corner. B. A cell with internal resistance of 1.0 o is connected in series withn5.0 oresistor and 3.0 N. The voltage across the 5 n resistor is 5 V. (al What current flows through the circuit? (b) What is the voltage across the 3 a resistor? iel What is the terminal voltage of the cell? (d) What is the emf of the cell? 9. There are 100 graduations In the scale of an ammeter with internal resistance of 0.18 n and intended to measure a current up to 10 A. (a) What is the value of each graduation? (b) Convert this to an ammeter that can measure up to 100 A. (c) How will the value of the graduations change? 10. There are 30 graduations in the scale of a voltmeter with an internal ading of 30 V.
Ex. 14 : A potentiometer wire has a length of 4 m and resistance 42. What resistance must be connected in series with the potentionmeter wire and a cell of e.m.f. 2V having internal resistance 20 to get a potential drop of 10 3 V/cm along the wire ?
During an experiment to verify Ohm's law, the voltage supplied and the current through a circuit are measured. [Voltage is measured in Volt (V) and current in Ampere (A)]. V www R A Battery The measured value of the current is I = 2.8 ± 0.1 A and that of the voltage is V = 18 ± 0.4 V. The resistance of the circuit %3D %3D (in Q) can be calculated using the formula, R =V/I, Calculate the, a) Resistance (in Q) = b) Fractional uncertainty in the resistance = c) Absolute uncertainty (in 2) in the resistance=
Circuit Problem: Express each labelled voltage and current (e.g., vx, ix) in terms of the resistances and source currents and voltages (e.g., R0).
In the circuit shown, the battery voltage, V = 15V and the load resistance, R = 15N. %3D R V A +, + Battery The ammeter reading is A. The Voltmeter reading is V.
Given the circuit below, determine the magnitude of the voltage reading across the terminals a and b. bo a T m w w 10 ohms www m 30 ohms 40 ohms 10 ohms 20 V A 15.2650 volts, B 2.4424 volts; The answer cannot be found on the other choices. D) 20 volts; ... 50 ohms T4 40 V
During an experiment to verify Ohm's law, the voltage and resistance of a circuit are measured. [Resistance is measured in Ohm (2) and voltage in Volts (V)]. www R A +, + Battery The measured value of the voltage is V = 9.8 ± 0.4 V and that of the resistance is R = 15 ± 0.4 Q. The current through the circuit (in Ampere (A)) can be calculated using the formula, I =V/R. Calculate the, a) Current (in Ampere) = b) Fractional uncertainty in the current = C) Absolute uncertainty (in Ampere) in the surrent
A potentiometer wire has a length of 4 m and resistance 40. What resistance must series with the be connected in potentionmeter wire and a cell of e.m.f. 2V having internal resistance 202 to get a potential drop of 103 V/cm along the wire ?
3:26 A docs.google.com Using ohm's law, determine how much electrical current will flow through this circuit. Your answer 60V ww Vこ? What is the voltage drop across the 4 ohm resistor?
The amount of charge flowing through a particular conducting wire is represented by the equation q (t) = at³ + bt? +c, where a = 5 A/s?, b = 3 A/s, and c is an unknown constant. When t = 0.9s, the voltage across the wire is measured to be 12 V. What is the resistance of the wire in Ohms?