A solution composed of 50% ethanol (ETOH), 10% methanol (MEOH), and 40% water (H20) is fed at the rate of 100 kg/hr into a separator that produces one stream at the rate of 60 kg/hr with the composition of 80% ETOH, 15% MEOH, and 5% H20, and a second stream of unknown composition. Calculate the composition (in %) of the three compounds in the unknown stream and its flowrate in kg/hr. F = 100 kg/hr mass fr >P 60 kg/hr mass fr Separator EIOH 0.80 MEOH 0.15 ELOH 0.50 МеОН 0.10 H,0 0.40 H,0 0.05 1.00 W = ? kg/hr %3D 1.00 kg/hr or mass fr ELOH OEIOH MEOH MMEOH OMEOH H,0 mH,0 WH,O W 1.00

A solution composed of 50% ethanol (ETOH), 10% methanol (MEOH), and 40% water (H20) is fed at the rate of 100 kg/hr into a separator that produces one stream at the rate of 60 kg/hr with the composition of 80% ETOH, 15% MEOH, and 5% H20, and a second stream of unknown composition. Calculate the composition (in %) of the three compounds in the unknown stream and its flowrate in kg/hr. F = 100 kg/hr mass fr >P 60 kg/hr mass fr Separator EIOH 0.80 MEOH 0.15 ELOH 0.50 МеОН 0.10 H,0 0.40 H,0 0.05 1.00 W = ? kg/hr %3D 1.00 kg/hr or mass fr ELOH OEIOH MEOH MMEOH OMEOH H,0 mH,0 WH,O W 1.00

Macroscale and Microscale Organic Experiments

7th Edition

ISBN:9781305577190

Author:Kenneth L. Williamson, Katherine M. Masters

Publisher:Kenneth L. Williamson, Katherine M. Masters

Chapter7: Extraction

Section: Chapter Questions

Problem 1Q

See similar textbooks

Similar questions

Human saliva contains the enzyme α-amylase which hydrolyzes polysaccharide acetal linkages. A soda cracker (containing starch) was carefully ground; the crumbs were distributed evenly between two test tubes. The first test tube contained only water, while the second contained a 1% solution of α-amylase. Both mixtures were heated to 35°C for 10 minutes and filtered. The filtrates were tested with iodine solution and Benedict’s solution. Use the following results to answer the questions below. Mixture Iodine test Benedict’s Test cracker in water dark blue blue cracker in water and α-amylase red red-orange precipitate a. Was the starch from the cracker/water mixture hydrolyzed? Was the starch from the cracker in the 1% α-amylase solution hydrolyzed? b. Which cracker contained reducing sugars?
A 25mL volumetric pipet is used to deliver a sample of the stock solution marked “0.6000M X2SO4” into a 100mL volumetric flask. Distilled water is added to the flask until it is about 3/4thfull, the solution is mixed well, then more water is added to fill it up to the calibration mark, then it is mixed again. Calculate the concentration of X+ion in the dilute solution made above.
4.0g of potassium hydrogen tartrate was added to 300mL distilled water. The temperature of the solution is 23.1C. The liquid was filtered and 50mL of the filtered solution was transferred to 250mL beaker, two drops of phenolpthalein was added to the 250mL beaker. The concentration of NaOH is 1.0 M that is filled in the 2mL graduate pipette, single drops of NaOH was added to the 250mL beaker until the solution turns pink and the potassium hydrogen tartrate reach the endpoint. The datd of four trials was collected. Please answer the following questions 4) calculate ksp for potassium hydrogen tartrate for each trial and average ksp for thr experiment 5) calculate the percent error in you value of ksp using reference that is found as the theoretical value. 6) why was the temperature of the saturated solution recorded?
SO4 -two content in 7689mL of a water sample was precipitated as Na2SO4. The precipitated was filtered, washed and calcined in an empty crucible with a mass of 27.0234g. The mass of the crucible plus Na2SO4 (142g/mol) was 27.7708g. Calculate the %m/v of Na (23g/mol) and the concentration of Na in the sample in ppm.
A 25.00mL wastewater sample was analyzed for its Mg2+ content using a standard gravimetric method. the sample was diluted to 3.00L and an 11.00mL aliquot was treated to precipitate magnesium as MgNH4PO4.6H2O using (NH4)2HPO4 as the precipitating agent. the precipitate was then filtered, washed, dried, and ignited resulting in a 0.1325mg Mg2P2O7 residue. How much Mg (in ppm) is present in the original sample
4.0g of potassium hydrogen tartrate was added to 300mL distilled water. The temperature of the solution is 23.1C. The liquid was filtered and 50mL of the filtered solution was transferred to 250mL beaker, two drops of phenolpthalein was added to the 250mL beaker. The concentration of NaOH is 1.0 M that is filled in the 2mL graduate pipette, single drops of NaOH was added to the 250mL beaker until the solution turns pink and the potassium hydrogen tartrate reach the endpoint. The datd of four trials was collected. Please answer the following questions 1) calculate the total volume and moles of NaOH required to reach the endpoint for each trial. 2) calculate the molar solubility of potassium hydrogen tartate ( in mol/L) for each trial. 3) calculate the average molar solubility of potassium hydrogen tartate for the four trials. What is the average solubility of potassium hydrogen tartrate in g/L? 4) calculate ksp for potassium hydrogen tartrate for each trial and average ksp for thr…
Oral rehydration salts are stated to contain the following components: Sodium Chloride 3.5g Potassium Chloride 1.5g Sodium Citrate 2.9g Anhydrous Glucose 20.0g 8.342 g of oral rehydration salts are dissolved in 500 ml of water. 5 ml of the solution is diluted to 100 ml and then 5 ml is taken from the diluted sample and is diluted to 100 ml. The sodium content of the sample is then determined by flame photometry. The sodium salts used to prepare the mixture were: Trisodium citrate hydrate (C6H5Na3O7, 2H2O) MW 294.1 and sodium chloride (NaCl) NW 58.5. Atomic weight of Na = 23. The content of Na in the diluted sample was determined to be 0.3210 mg/100 ml. Determine the % of stated content of Na in the sample. The stated should be 104.5, how??
The solubility of suberic acid C6H12(COOH)2 is 0.14 g/100 ml H2O and 0.56g/100 ml ethyl ether at 15 0C. Calculate the weight of suberic acid removed from 50 ml aqueous solution containing 40 mg acid by extraction with 50 ml ether. Calculate the weight of acid that would be removed by two successive 25 ml extraction with ether.
A sample of an infusion was diluted 10 ml to 250 ml and then 10 ml to 200 ml. It was thenanalysed and was found to contain sodium at 0.789 mg/100 ml. Calculate the concentrationof sodium in the original sample in %w/v. The sample was composed of a mixture of sodiumlactate and sodium carbonate in equimolar amounts. Calculate the amount of sodiumlactate and sodium carbonate in mg/10 ml of the sample (Na = 23, lactate = 89, carbonate =60)
Oral rehydration salts are stated to contain the following components: Sodium Chloride 3.5g Potassium Chloride 1.5g Sodium Citrate 2.9g Anhydrous Glucose 20.0g 8.342 g of oral rehydration salts are dissolved in 500 ml of water. 5 ml of the solution is diluted to 100 ml and then 5 ml is taken from the diluted sample and is diluted to 100 ml. The sodium content of the sample is then determined by flame photometry. The sodium salts used to prepare the mixture were: Trisodium citrate hydrate (C6H5Na3O7, 2H2O) MW 294.1 and sodium chloride (NaCl) NW 58.5. Atomic weight of Na = 23. The content of Na in the diluted sample was determined to be 0.3210 mg/100 ml. Determine the % of stated content of Na in the sample.
A spent 1.0 percent caustic soda solution (ρNaOH = 8.42 lb/gal) with a volumetric flow rate of 3.0gpm is to be neutralized using either sulfuric acid or hydrochloric acid. First, determine the massflow rate (lb/day) of NaOH in the spent caustic soda solution, and then use that value todetermine the stoichiometric amounts (lb/day) of:1. H2SO4 required for neutralizing the OH− ions contributed by the spent caustic soda.[Hints: (1) write the balanced chemical equation for the acid-base reaction betweenNaOH and H2SO4, and use it to establish the stoichiometric weight ratio H2SO4 : NaOH.]2. HCl required for neutralizing the OH− ions contributed by the spent caustic soda. [Hints:(1) write the balanced chemical equation for the acid-base reaction between NaOH andHCl and use it to establish the stoichiometric weight ratio HCl : NaOH.]
You are required to prepare 5 L of a solution containing 1.000 x 103 mol/L of Cu2"(aq). Which of the following procedures would produce an appropriate solution? O Dissolve 0.0636 g of copper metal in nitric acid, add to a 5.000 Lvolumetric flask, dilute to the mark with deionized water and mix well. O Dissolve 1.248 g of CuSO.5H,0(s) in deionized water, add to a 5.000 L volumetric flask, dilute to the mark with deionized water and mix well. Dissolve 0.250 g of CUSO,.5H,O(s) in deionized water, add to a 5.000 L volumetric flask, dilute to the mark with deionized water and mix well.