a 0.031-m insulation whose dielectric constant is 5. Another material 0.012 m thick is inserted between the plates Determine the dielectric constant of the material if the new

Q: Australians use the n76 band at 3.5 x 109 Hz. Determine the wavelength at this frequency. Show clear…

A: Given data, Frequency f=3.5×109 Hz Speed of light c=3×108 m/s

Q: Q2: A PMMC(Galvanometer instrument) has a resistance of 10002 and FSD for a current of 400Au. A…

A: In this question we need to determine the various range of given ammeter.

Q: Derive the operating point ,Q-pt.,  of the BJT voltage-feedback bias circuit shown.

A:

Q: A carrier signal given by 10 cos 2m x 10°t volt is FM modulated by single tone Hz message 4 cos 2 x…

A: It is given that: ct=10 cos2π×108t Vm(t)=4 cos2π×103t Vkf=1000 Hz/V

Q: 220 V 60 Hz R R = 25 Q2 L V₁ L=6 mH C HI Ve C= 100 μF

A:

Q: A balanced negative sequence 3-phase system consist of Y-connected load supplied by a balanced…

A:

Q: An air craft control system has H(s) = 1 and G(s) = Determine the: a) b) c) Gain margin Phase margin…

A: Given: An aircraft control system has a feedback gain of  Hs=1, and forward path transfer function

Q: of what is the type of synch Gen according to excitation & Compore between them.

A: Here we discuss about the synchronous generator.

Q: 1+ V1 R1 R2 resistor is an electronic component that determines the amount of electric current in…

A: Given data, R1=461 Ω Current flowing though the circuit i=7.85 mA = 0.00785 A Supply voltage V1=7 V

Q: 2. In what conditions will the thyristor continue conducting? How to turn off the thyristor?

A: Condition in which thyristor will continue conducting :   The main condition for a thyristor to be…

Q: Two point charges exert force of 0.291 grams on each other. If the charges are 8.5 cm apart and with…

A:

Q: Describe how digital signals are transmitted over a telephone line or TV cable

A: Digital signals can be transmitted over the transmission line using either serial or parallel…

Q: nd the Vx in the network below jΤΩ 2 Ω 8/30° V Μ j4Ω 2 Ω V₂ j4Ω -j1Ω Μ 2/0°

A:

Q: Design a voltage-divider bias network using a supply of 24 V, a transistor with a beta of 110, and…

A: The voltage divider bias network usually uses two resistors connected in series, and a lower value…

Q: The impedances Z₁ = 6 + j8, z₂ = 8 − j6, and z3 = 10 + j0ohms measured at 50Hz from branches of a…

A: In this question parallel connected circuit is given....We have to find out fourth element to he…

Q: (1) find the transfer function V/l; and obtain zeros and poles. 50 0.1 loo 2H

A: Given circuit : The value of circuit capacitance C=0.1F The value of circuit inductance L=2H And…

Q: In the system shown in Figure 7.16, a three-phase short circuit occurs at point F. 7.16 operating at…

A: To find the fault current in power system, first it is important to find the base value of voltage,…

Q: What type of RCCB's we must use in AC Circuits? Can we use RCCB in DC circuits? Why?

A: RCCB- It is a protection device used in protection of electricity system. It is residual current…

Q: ) At t<0, the circuit in Fig.5 is steady state. The switch is change as sho Vs1-35V Vs2-130V R1=17ΚΩ…

A: In this question we will find current through capacitor just after switch closed...

Q: In the Y-A system shown in figure below, the source is a positive sequence with Van = 24020° V and…

A:

Q: Draw a schematic diagram of a forward bias diode.

A: Generally diode will works only in two modes of operation such as forward and reverse biasing.…

Q: A 250 V, 10 hp series motor is mechanically coupled to a fan and draws 30 A and runs at 500 rpm when…

A: Given: A 250 V, 10 hp series motor is mechanically coupled to a fan and draws 30 A, and runs at 500…

Q: compare a half wave bridge rectifier with a reversed diode and a non-reversed diode.

A: Given: Half wave bridge rectifier with a reversed diode and non-reversed diode

Q: Sketch and explain the output for the circuit of given parameters. The generator signal is a sine…

A: In this question,  We need to Sketch the output voltage waveform Using Third Diode Approximation?…

Q: For the given network below find the a - VD , b-VC , C-VG , D-VGSQ , e-IDQ , f-IE , j-IB

A: The given circuit diagram is shown below:

Q: List the responsibilities of the project contractor

A:

Q: 2. Determine the rms value for each of the waveforms shown in figure below. (a) e (V) hour 2 2 5 7…

A:

Q: Q3/ Compare betwen spit & capacitor motor

A: Types of single phase induction motor depending on their winding arrangement  Split phase motor…

Q: A single phase transmission line is delivering 460 kVA load at 11 kV. Its resistance is 6.5 Q and…

A: Given: A single phase transmission line is delivering power to load SL=460 kVAVL=11 kV…

Q: C is ↑ 7.5 mH 12 Ω For the circuit shown above, what is the maximum average power that can be…

A:

Q: 28. The primary current of a transformer with 240 volts on the primary, 10 amps on the secondary and…

A: given here some fill in the blank questions and asked to fill the blanks with explanation.   NOTE:…

Q: Draw a schematic diagram of a switching transistor

A: A simplest application of a transistor is to use it as a switching device(more appropriately as the…

Q: Solved: Write a program to implem... www.chegg.com • The agitate motor starts automatically and runs…

A: Given: Problem

Q: nd the currents and the voltages in the circuit shown below i₁ 8 Ω 13 α V + 30 V + V2 www dis 3Ω Vg…

A:

Q: ▶2/222 Under the action of force P, the constant accelera- tion of block B is 3 m/s² to the right.…

A: It is given that: a=3ms2v=2ms

Q: Draw a single-layer, short-pitch (5/6), distributed lap-winding for a 3-phase, 4-pole, 48 slot…

A: Alternator:- Alternator is a machine which is used to convert the mechanical energy into the…

Q: Referring to the Figure 1 below, set the value of voltage Vs as: - Vs (rms) = (120+the last 2 digit…

A:

Q: What is the radius of a copper cable having resistance of 10 ohm and length of 10 km. Assume the…

A: Given data, R=10 ΩL=10 kmρ=1.7×10-8 Ωm

Q: Hi there, for the bode diagram in the screen shot attached can you please work out the following.…

A: The asymptotic Bode magnitude and phase plots are given in the question. From the Bode plot we need…

Q: find the fouriar series of function f(x)={-x where -3<x<0 ,x where 0<x<3}

A: It is given that: fx=-x      -3&lt;x&lt;0x             0&lt;x&lt;3

Q: Using Norton's Theorem, what is the value of RN to calculate the current 1₁ of the circuit below?…

A: In this question,  We need to determine the Norton resistance RN  using the norton theorem to…

Q: Q4. The open-circuit and short-circuit test readings for a three-phase, Y-connected, 1 MVA, 2 kV,…

A: Given data, Voltage V=2000Volts

Q: .Design equation F(A,B,C,D)=E(1,2,3,6,8,10,12,13,15) using a 4x1 Mux?

A: Follow the Boolean laws provided  Compare the obtained F with standard multiplexer notations and…

Q: An averaging amplifier have five inputs with RF = 30 kohms, what should be the value of each input…

A: When all of the input resistors are equivalent, the summing amplifier is termed an averaging…

Q: Length of Director , LD Length of Reflector,LR Spacing from Director to Driven Element, SR-DE

A: Since there are multiple sub-parts, as per the guidelines, in the following section, only the first…

Q: Give the value of the following resistors: (Must write final value to short notation using KOhms,…

A: The objective is to determine the color code.

Q: The poles of the system G(s) = (s + 2)/ (2s + 8) is a. -2 b. 4 C. -8 d. -4

A: Given: The system transfer function, Gs=s+22s+8

Q: 1. Compute for 5V for No accross tkn resistor si TUO F IK2 1. find also the current I

A: We need to find out current and voltage for given circuit

Q: Please answer all subparts for like either dislike is ready..Please sir

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 3A O (+1. SV ww ww R1 160 R1 160 R2 40 R2 40 ww R3 50 +V1 12 V Figure 1(a) R3 50 Figure 1(b) ww R4…

A:

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.