1) In capacitors, the time constant determines the discharge rate.   True or False 2) AC currents change direction.   True or False   3) Three 1 Ohm resistors are in series.  The total resistance is 1/3 Ohm, (b) 3 Ohms, (c) 1 Ohm, (d) none of the above

Q: Q4) Determine the power and rms value for each of the following signals: a) (10+2sin3t)cos10t b) 10…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: A 4 pole dc generator with duplex wave winding has 72 slots, 4 conductors per slot. The flux per…

A: DC generator: This is an electromagnetic machine that works on the electromagnetic inductor…

Q: ?Why QAM is important Increasing bandwidth Decrease noise Increase power Increasing bit rate

A: It is a combination of ASK and PSK which increases the number of bits that results in changing the…

Q: A 4 pole dc generator with duplex wave winding has 48 slots and four elements per slot. The flux per…

A:

Q: A₁ L Ao Ao HL Ao /1. VDD 오 9 VDD VDD VDD 0 (00) 1 (01) 2 (10) 3 (11)

A: Given digital circuit  The function of the given digital circuit is explained in below steps.

Q: 31. The all-day efficiency of a transformer depends primarily on (a) its copper loss (b) the amount…

A: As per bartleby guideline for more than three mcq asked only first three are to be answered please…

Q: Find I(t) t = 0 24 Ω 6A (1) Answer: 2e 12 Ω Μ 5 Ω 2Η A, t > 0. 8 Ω

A:

Q: A system that behaves like x[2n-2] at the output, when a signal is input input x[n], is shown on the…

A: The output will be sinx (T-t) if the system is sent through the time delay first, then via the…

Q: Q3) Mesh Analysis a) Write mesh equation for loop current I, and then simplify it in terms of I, and…

A: Given circuit,

Q: An impedance coil having a resistance and inductance of 2 ohms and 1.5 mH, respectively, is…

A: In series RLC circuit  at resonance             XL = XC

Q: Given the magnetic circuit, calculate 3 from the right column if the coil wound in the left column…

A: Magnetic flux is the number of magnetic lines passing through the magnetic field. It is similar to…

Q: Calculate the value of Zab in the network j6 Ω -j9 Ω α. m -j9 Ω bo j6 Ω j6 Ω 20 Ω ell 20 Ω 9 Ω 10 Ω

A:

Q: 1. If the load of wye connected transformer are: IA = 10 cis(-30°) IB = 12 cis (215°) Ic = 15 cis…

A:

Q: Design a Single-Stage Common Emitter Class A Amplifier Specifications: Voltage Divider Bias Circuit…

A: The common emitter amplifier is a voltage amplifier that is made up of three single-stage bipolar…

Q: Activity 2: (Nanotechnology) Research about nanotechnology and cite at least 10 examples of how it…

A: Nanotechnology is the study, sculpting, and combining of matter just at atomic and molecular level.…

Q: 2- Determine the number of turns per-phase in each winding of a 3-phase transformer with a ratio of…

A:

Q: The ac bridge shown in Fig. 9.84 is known as a Maxwell bridge and is used for accurate measurement…

A:

Q: H.W.: A copper wire of commercial purity is needed to conduct 10 A of current with a maximum voltage…

A:

Q: Question1): Find the current and voltage for each element in the fig. (1) Sketch the v and curves.…

A:

Q: An inverter with a resistive load, VDD = 3.3 V, P = 0.1 mW, VL = 0.2 V, K'n = 60 UA/V2 and VT N =…

A: Solution- Given,VDD = 3.3 VP = 0.1 mWVL = 0.2 VKn' = 60μA/V2VTN = 0.75 V Let transistor operate in…

Q: *14. For the circuit of Fig. 19.51: a. Find the total number of watts, volt-amperes reactive, and…

A: The required ac parameters can be calculated by using the basic laws.

Q: 1. If the load of wye connected transformer are: IA = 10 cis(-30°) IB = 12 cis (215°) Ic = 15 cis…

A: Positive sequence: This sequence has equal magnitude of the three vectors as the original sequence…

Q: Calculate the current in the 10-ohm resistor using Kirchhoff's law I, E₁1 = 10 2 10 E₂=4 3

A:

Q: Determine IDQ, VGSQ, and VDS for the network of Fig below.When VDD=40V, RD=3K, RS=1K, R1=24M,…

A: A JFET is a junction field effect transistor. It is a semiconductor device with three terminals…

Q: A controlled rectifier whose firing angle at 60 supplies a load RLE. The voltage is 120 V, R 30…

A: In this circuit the concepts related to the phase controlled converter is discussed.

Q: B). Three identical impedance are connected in delta across a 450V supply. The current in one of the…

A:

Q: The set of independent of voltages are recoded as :50.8, 50.5, 50.2, 50.1, 50.3,50.6. Calculate:…

A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…

Q: Calculate the value of Zab in the network j6 Ω -j9 Ω m j6 Ω j9 Ω || bo j6 Ω 20 Ω Μ 20 Ω -j9 Ω 10 Ω

A:

Q: 3- Plot3 helps in creating 3D lines and 2D lines. A:YES B: NO 4- The ----------enables you to add…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: What is the largest number that can be represented using eight bits? a) In decimal system b) In…

A: 8-bits  8-bit is a computer information measurement that was commonly used to refer to hardware and…

Q: Find the current Supplied by each battery in the Circuit Shown in fig. applying Maxwell's loop…

A:

Q: Explain the steps that are required to use an ideal transformer in order to match a 500 ohn load…

A: Solution-  Let, Where Vs = source voltage             Zs = source impedance            ZL = load…

Q: Two- Explain what is the difference and commonality between the transfer function and the state…

A: This question is related to control systems

Q: Identify the given statement. Lead and mercury are examples of superconductors. Select your answer.…

A: Superconductors: A superconductor seems to be a substance that obtains superconductivity, a state in…

Q: Q1: A JFET with parameters of Ipss = 3mA and VGS(OFF) = Vp = -6V is used in a circuit shown in…

A:

Q: Q2: A JFET has parameters of Vp=-6V and lpss=3mA. Plot the transconductance curve for the devi Using…

A: JFET Features Voltage controlled Device Fast switching device High input impedence  Smaller size…

Q: If the gate-to-source voltage. in an n-channel E-MOSFET is made more positive, dose the drain…

A:

Q: Discreet Mathematics Create the logic circuit diagram for F= XY’ + XZ

A:

Q: It is the ratio of the potential difference between the two ends of the conductor to the current…

A: Ratio of potential difference between the two ends of the conductor to the current through the…

Q: Design a logic circuit that controls the passage of a signal A according to the following…

A: In this question we design a logic circuit that controls the passage of a signal A according to the…

Q: Refer to the Figure below, calculate Z₁. Assume VGSQ = -2.2V. = VDD-12V, RD-3.5kohms, Rs-1.0kohms,…

A: Brief description: For the given common gate amplifier circuit we need to derive its input…

Q: 1- Consider the circuit shown in Fig. 1. Given that R₁=1.5k02, R₂=1.2k2, R=1k0 and R₁=1.8kQ2, find…

A: Note :  QUCS is a software application so it will be not possible to verify the voltage by QUCS so i…

Q: Q1/ For the below system, if you know that the input is (t) = A sin(wt) explain and draw the…

A:

Q: A wall has an area of 75 m2 and has a thermal conductance of 1.6 W/m2-°C. If there are 2,250…

A: Given a wall has, An area, A = 75 m2 Thermal conductance, K=1.6 Wm2-°C Temperature gradient,…

Q: A 1-ph transformer 25kVA, 330 10V, 50Hz, Req2 = 0.04592 and Xeq2 = 0.06592 draw the Kapp regulation…

A: Single Phase Transformer: A single phase transformer is an electrical device that accepts…

Q: Q1/ Find the state and output equations for the electrical network shown in The below figure if the…

A: A first-order linear differential equation, or a set of linear differential equations, is the state…

Q: List 4 examples of primary energy sources.

A: Primary energy sources are the sources of energy which are naturally available to use without any…

Q: 3. A 12-pole, 420 V, 10 kW, 50 Hz, three-phase induction motor gave the following test results.…

A: Given data, Open circuit test data:- Voltage per phase (V)=242.49V OC test loss=500W Mechanical…

Q: 6/ (a) Describe the basic Microwave transmission system and give the importance of each component in…

A: (a) Microwave transmission system : A microwave link is a communications system that uses a beam of…

Q: The circuit below is supplied from sinusoidal voltage source v(t) = 1 sin wt. The magnitude of…

A: Brief description: For the above given RLC circuit we need to calculate it's resonance frequency and…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.